Bluetooth Shield for Arduino

£ 14.30

FREE DELIVERY

This Bluetooth shield is a serial port Bluetooth module (Slave) breakout board,
integrating a HC-06 Serial Bluetooth module and is compatible with Arduino. You can directly plug in with Arduino and use the UART port for Bluetooth communication.

The shield has a full Arduino footprint , and a stackable socket for connecting with other Arduino shields like the Ethernet shield or SD card shield.

This unit has a power selector switch so now you can not only use it with 5V interface boards like Arduino, but also with many other 3v3 boards like IFAT-32, Leaf Maple, and so on.

Also included is a prototype area on board for building a small circuit for the bluetooth shield


  • Iteaduino / Arduino UNO compatible
  • Up to 10m communication distance in house without obstacle
  • UART interface (TTL) with programmable baud rate (SPP firmware installed)
  • Default baud rate: 9600
  • data bits: 8,
  • stop bit: 1
  • Parity: No parity
  • Default PINCODE:”1234”
  • A full set of configuration commands
  • On board PCB antenna
  • FCC ID certificated
  • Board Size: 54mm x 47mm
  • Operation Level Digital 3.3V or Digital 5V
  • Stackable: Yes
  • Arduino Deumlanove/UNO
  • Arduino MEGA
  • ChipKit MAX32
  • ChipKit UNO32
  • FEZ Panda II
  • Freeduino
  • Iteadmaple
  • Iteaduino
  • Iteaduino ADK
  • Iteaduino MEGA 2560
  • Simple Cortex
  • Seeeduino
  • Seeduino MEGA
  • 1 x Brand new Boxed Bluetooth Shield

Bluetooth Shield for Arduino

Stackable plug and play board requiring very little to get started.

  • Bluetooth Shield
  • Arduino

Bluetooth Test Code


void setup()
{
  char temp;
  pinMode(13,OUTPUT);
  Serial.begin(9600);
  
  while(1)
  {
    if (Serial.available() > 0 )
    {
      temp = Serial.read();
      if(temp == '1')
        digitalWrite(13,HIGH);
      if(temp == '0')
        digitalWrite(13,LOW);
      Serial.print(temp);
    }
  }
}

void loop()
{

}